 |
What do you do if your Chevy Malibu will not start after you replaced the ignition?In: Chevy Malibu [Recategorize] |
[Edit] |
[Edit] 
Answer
you did not mention what year, but are you sure it was the ignition and not the anti theft system. If you think it could be the anit theft system, than you can try turning the key on for 10 minutes and than off for on e and repeat this and than see if it starts.
First answer by ID1182146634. Last edit by ID1182146634. Question popularity: 21 [recommend question]
|
Research your answer: |
Can you answer other
questions about Chevrolet Malibus?
- How do you remove the stereo from a 2005 Chevy Malibu?
- Is a 2004 Chevy Malibu good on gas?
- 1996 dodge ram pickup and your problem is that the gas gauge is all over the place and sHow is full one minute and then 12 tank and 10 min later it sHow is empty then full again later that day?
- How do you disable the anti theft system so that the car will start on a 2003 Chevy Malibu?
Answers.com > Wiki Answers > Categories > Cars and Vehicles > American Cars > Chevrolet > Chevy Malibu > What do you do if your Chevy Malibu will not start after you replaced the ignition?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
1998 chevy malibu motor replaced? You replaces your ignition and know it wont start?
